Analogue / Linear / Mixed Signal ICs

Designed to support the supervisory circuits of microprocessors, the APX803L micro-power voltage detector from Diodes offers a detection between 1.2 and 5.0V in 0.1V steps, while consuming 1μA (typ, 2.5μA max). Threshold accuracy is ±1.5%, and no external components are required. Whenever the monitored power supply rail drops below the chosen threshold, the APX803L asserts a reset signal within 20μs ...

LTC2063 from Analog Devices draws just 1.3μA (typ, 2μA max) from a 1.8V supply and achieves 5μV maximum input offset at 25°C

Microchip has introduced a range of CAN transceivers which includes an automotive Grade 0 qualified device. Designated the ATA65XX family, the devices support the recently established CAN FD (Flexible Data-rate) protocol for up to 5Mbit/s communication speed and the new CAN PN (Partial Networking) standard for improved energy efficiency for vehicles. The devices are compliant with the ISO 118980-2/5/6, 11898-2:2016 ...

Toshiba has introduced a 40V/3.0A stepper-motor control IC that requires no external current-sense resistors. The TB67S508FTG stepper-motor controller has on-chip current sensing. As a result it can eliminate the effects of resistor-tolerance errors, ensuring greater accuracy (+/-5%) and uniformity, says the supplier. The transistors of the output bridge have very low on-resistance of 0.45Ω (typical, high-side + low-side). The device ...

Linear Technology, now part of Analog Devices, has launched the LTC2358-18, an 18-bit, 8-channel simultaneous sampling SAR ADC featuring integrated picoamp input buffers. The LTC2358-18 from Linear Technology, now part of Analog Devices, saves board space  by eliminating front end signal conditioning circuitry normally required to drive unbuffered switched-capacitor ADC inputs. The combined component savings of three amplifiers, six resistors and two capacitors ...

A 32-bit successive approximation register (SAR) analogue-to-digital converter with dual outputs and digital filters to optimise signal bandwidth has been introduced by Linear Technology, now owned by Analog Devices. The LTC2500-32 provides a digitally filtered output that achieves up to 148dB of dynamic range as well as a no latency output comprising an over-range detection bit, a 24-bit representation of ...

How to avoid amplifier output driver saturation when using very low bias current amplifiers with high source impedance sensors, write Jon Munson and Kevin Scott When taking sensor measurements, the type of sensor excitation used typically varies greatly. It can be a DC signal, an AC signal, a voltage source, a current source or a pulsed source, to name a ...

Analog Devices has announced hardware for learning about analogue circuits and software-defined radio. USB-powered and controlled, ADALM2000 Active Learning Module includes: two analog differential inputs, two analog single-ended outputs, and two power supplies. 12bit 100Msample/s DACs and ADCs provide the digital interface, and once coupled with the firm’s Scopy software running on a computer (Windows, Linux or OS X), the ...

TI combines a modified chopper architecture with a proprietary input for an op-amp whose precision extends to common-mode signals anywhere within its power rails.

Linear Technology introduces a dual channel mixer which has integrated programmable variable gain IF amplifiers.